Grinding of the shaft Ø3.5
All our hobbing tool holders with a Ø3.5mm milling shaft are ground after assembly in order to guarantee better precision during machining. This process is also performed for all revisions of these tool holders.
All our hobbing tool holders with a Ø3.5mm milling shaft are ground after assembly in order to guarantee better precision during machining. This process is also performed for all revisions of these tool holders.
Your cart is empty
© PCM Precision Tooling Ltd. | 1969 - 2024 | General conditions of supply |
CMS & webdesign: www.pub-rutz.ch
Tél. +41 21 967 33 66
Route du Grammont 101
1844 Villeneuve, Suisse
To facilitate your request, you can now contact the desired department directly as listed below.
Customers: order & quotation
Phone +41 21 967 33 66
Service & Repair
Technique & Design
Suppliers: order confirmation & quotation
Invoices
Accounting
Human Resources